Τ餻&
- 2021ǯ415
[AJL] Weft breakage outside the woven fabric
Check the timing of the end of blowing of the main nozzle About the actual behavior of the air valve Above actuallyBelow ideal When the air valve closes, the air does not completely come out at t […]
- 2021ǯ414
[AJL] Weft insertion trouble end curling
Check the sub nozzle on the end side Make sure that the sub-nozzle on the end side has the recommended settings. Often, the number of sub-nozzles is insufficient, or the angle of the sub-nozzles is […]
- 2021ǯ412
[AJL] Weft insertion trouble end curly
-1 Confirmation of reaching angle Check if the weft arrives too late or too early. Determine the timing of arrival at each sub-nozzle from the timing of arrival of the weft. Then, check if the injec […]
- 2021ǯ49
[AJL] Weft insertion trouble large loop
-1 Pressure check of sub-nozzle It depends on the old and new looms and the type of sub-nozzle. Basically, the sub nozzle should be set above the pressure of the main nozzle. When it comes to new lo […]