-1 Pressure check of sub-nozzle It depends on the old and new looms and the type of sub-nozzle. Basically, the sub nozzle should be set above the pressure of the main nozzle. When it comes to new lo […]
-1 Check the height of the sub nozzle The height of the sub-nozzle is related to the thread carrying force, but it is not necessary to adjust all to a uniform height. If the number of sub-nozzles, w […]
Check the injection timing of the sub nozzle Check using the above sheet. The new loom(after JAT600) sets the timing automatically. However, there are times when the automatic settings are out of o […]
Sub-nozzle and piping check Checking the air pressure Check the pressure by injecting air from the sub nozzle in manual mode. If there is a nozzle whose air pressure from the sub nozzle is weaker t […]
The breeze volume is not suitable Care must be taken when weaving a fine count fabric after weaving a thick count fabric. The breeze volume for thick counts and the breeze volume for fine counts ma […]
Temple check Make sure the cloth has not fallen from the edge of the temple. If it has fallen, the condition of the opening will change. normal. The edge of the cloth has fallen. Change the angle […]
Checking the frame height Is the lower thread at the time of opening higher or lower than the standard? If you hang the frame with a wire, check the frame height once every few months. Or check t […]
Check the mounting position of each part near the crank angle of 180 Is there a tandem nozzle on the center line of the EDP? Is the mounting position of the tandem nozzle and the main nozzle in a […]
When the cause is the cutter on the left Is the tip of the thread fluffy after cutting the weft? If the cutter becomes dull, the tip of the thread will become fluffy. Since it is not completely […]
The posture seen from the nozzle is strange. Is the breeze pressure extremely high or low? If it is too high, the tip of the thread will run wild, and if it is too low, the tip of the thread wil […]