Weaving process technical page ① Check the tension of the warp at the weft entrance of the woven fabric② When the cause is poor opening of the warp③ Caused by the thread④ The posture seen from the nozzle is strange.⑤ When the cause is the cutter on the left⑥ Check the mounting position of each part near the crank angle of 180 °⑦ Checking the frame height⑧ Temple check⑨ The breeze volume is not suitable ① Sub-nozzle and piping check② Check the injection timing of the sub nozzle③ Check the height and angle of the sub nozzle④ Pressure check of sub-nozzle and Drum pin timing check ① Confirmation of reaching angle and standard deviation② Check the sub nozzle on the end side ① Check the timing of the end of blowing of the main nozzle② Check the weft insertion angle and reaching angle③ Reduce rpm ① Check the distance between the solenoid pin and the measuring length band② Wear check around the solenoid pin③ Check the balloon sensor
